Category » Sensors

There were 6 articles found in this category:

1. Flexible Conforming Pressure Mat Sensor - DISCONTINUED
   Flexible Conforming Pressure Mat Sensor Diamond Traffic Products has developed a flexible, portable or permanent pressure sensing mat for installation in foot, bicycle or snowmobile trails; as well as dirt or gravel roads for axle sensing. As a sensor, this mat is suitable for counting people, ...
2. Piezo Termination for UPP units.
   Terminating Piezo sensors usually is done one of two ways. Either the termination is done using a terminal block and then connected to the counter using the UPP piezo harness or by individual BNC connectors. With the Terminal strips the wiring must be done on site to "land" the piezo sensors ...
3. NORTH AMERICAN PHILIPS (Unencapsulated Sensors)
   NORTH AMERICAN PHILIPS (Unencapsulated Sensors) The bare piezo electric axle sensors differ from the Philips aluminum channel encapsulated sensor by having a rigid copper tubing outside sheath. Sensor may be installed in 3/4" (2 cm) wide x 3/4" (2 cm) deep slot cut across the pavement. Sensors ...
4. PIEZO / ELECTRIC ROADWAY MOUNTING FRAMEWORK
   ROADWAY MOUNTING FRAMEWORK This mounting frame is designed to be permanently installed in the roadway. The frame has a locking bar secured with machine bolts that allow piezo or resistive sensor units to be replaced without sawing out the old sensor and grouting in the new one. The frame work i ...
5. PIEZO ELECTRIC AXLE SENSOR
   PIEZO ELECTRIC AXLE SENSOR These are permanently installed axle sensor (class II) or weighing grade (class I) axle sensors manufactured by North American Philips. The sensor element is secured in an extruded aluminum channel with sand filled epoxy or flexane 80. The sensor is normally availabl ...
6. AMP ATOCHEM Brass Linguine (Unencapsulated Sensors)
   AMP ATOCHEM Brass Linguine (Unencapsulated Sensors) Class I (WIM) and Class II (Axle Sensor Only). This flat 1/16" (1.5mm) x 1/4" (6mm) brass piezo electric axle sensor can be taped temporarily to road surface or permanently installed by grouting into a 3/4" (2cm) wide x 3/4" (2 cm) deep slot ac ...