Piezo Termination for UPP units.

Terminating Piezo sensors usually is done one of two ways. Either the termination is done using a terminal block and then connected to the counter  using the UPP piezo harness or by individual BNC connectors.   With the Terminal strips the wiring must be done on site to "land" the piezo sensors to a terminal block and then "land" the Harness to plug into the UPP counter. With the BNC connectors the counter must have BNC style inputs or a breakout box or converter must be used.

When terminating the Piezo sensors the piezo sensor cable will most likely be a coax cable which will need to be wired to a terminal as in the diagram below.  With BNC connectors the BNC connectors themselves must be attached in the field.

terminal wiring diagram.jpg

Related Articles

No related articles were found.


No attachments were found.

Visitor Comments

Article Details

Last Updated
21st of October, 2011

Pegasus, Phoenix, Phoenix RAX, Phoenix RAX II, Unicorn

Would you like to...

Print this page  Print this page

Email this page  Email this page

Post a comment  Post a comment

 Subscribe me

Subscribe me  Add to favorites

Remove Highlighting Remove Highlighting

Edit this Article

Quick Edit

Export to PDF

User Opinions

No users have voted.

How would you rate this answer?

Thank you for rating this answer.