http://support.diamondtraffic.com/knowledgemanager en-us http://support.diamondtraffic.com/knowledgemanager ActiveKB NX support@diamondtraffic.com Fri, 03 Apr 2026 23:07:52 PDT 20 http://support.diamondtraffic.com/knowledgemanager/questions/123/ Command available in UPP 4.16 and 4.56 and higher Firmware. When subtracting minutes from the clock – This function causes the counter to reset the clockback one minute at the beginning of ... Colin Gibson Tue, 21 Aug 2012 22:47:31 GMT http://support.diamondtraffic.com/knowledgemanager/questions/117/ It is important to note that the Station ID referenced in Centurion’s Database is the Same Site ID that is referenced in our counters and classifiers. Each Location that you collect data fr ... Jesse Brady Fri, 21 Oct 2011 22:24:26 GMT http://support.diamondtraffic.com/knowledgemanager/questions/113/ Terminating Piezo sensors usually is done one of two ways. Either the termination is done using a terminal block and then connected to the counter using the UPP piezo harness or by individual BNC ... Colin Gibson Fri, 21 Oct 2011 22:22:59 GMT http://support.diamondtraffic.com/knowledgemanager/questions/39/ Overview The tables below describes the default bins categories that are used with the Pegasus, Phoenix and Unicorn MDK units. These “Bins” are used to total up all vehicles meeti ... Jesse Brady Mon, 17 Oct 2011 23:23:27 GMT http://support.diamondtraffic.com/knowledgemanager/questions/18/ The following is a list for known compatibility: Apollo: All Versions DataHog: 1.50+ Pegasus: 2.39 - 2.45 Phoenix: 2.39 - 2.45 Unicorn: 2.39 - 2.45 Unicorn Limited: All VersionsSprite: 1.40+Trail ... Colin Gibson Mon, 17 Oct 2011 20:11:25 GMT